ITS Home  |  Service Catalog  |  Knowledge Base  |  Support Center  |  Contact ITS Service Desk     

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »

Cal Poly Service Desk staff sometimes run into common issues and will share Solidworks troubleshooting information in this section.

Cal Poly Service Desk staff have reported that the installation could take approximately 30 minutes to complete from start to finish on average. Please be sure to plan accordingly to avoid interruption/errors...

 If SolidWorks Shows as Not Activated When Opened...(Windows)
  1. Open the SolidWorksSetup.exe file from the initial SolidWorks download.
    – You can download this from software.calpoly.edu if you can’t find it). Unzip when prompted.
    – If the error window opens with the message “A Windows reboot is pending from a previous installation…”, just press OK

  2. Select Modify your installation and click Next.

  3. Make sure the correct serial number is shown. It should end in NZ27.
    – The entire serial number can be found on software.calpoly.edu.

  4. Continue through the rest of the Installation Manager, nothing else should change. Click Modify Now on the final page.
    – An error message should appear with a specific file path, something like C:\Users\user\Documents.

  5. Navigate to the file path in File Explorer and open the SOLIDWORKS 2022 SP02 folder.

  6. Right-click on swdata99.id and rename it to swdata99.txt.
    – Under the View tab in File Explorer, you may need to check File name extensions before you can do this.

  7. Open swdata99.txt and change the text so that it reads SOLIDWORKS 2022 SPXX.XX.

  8. Save the file (File > Save), close it, and rename the swdata99.txt file back to swdata99.id

  9. Go back to the installation manager and click Modify Now again.
    – You may have to restart the Installation Manager for it to go through (redo steps 1 through 5).

  10. Open SolidWorks. It should now be activated.


  • No labels